cyclic movement

[gaurdian101]

ok my first fbl heli and first time setting up the ar7200bx works great but my cyclic movement one moves faster moving it to the left than the right.. even looking at the swashplate and servo's move fast moving one way than the other

[M&P_Hooligan]

do they move slow when returning to center or during stick inputs?

what servos?

Never noticed an issue with any of mine with the AR7200. others may have more experience

[gaurdian101]

they do move slow when returning to center or during stick inputs....it just seem really slow and takes a long time to get to the throw going one way that the other


the servo's are ds510 this is an align 500esp that I made fbl last night I did to hovers works great but just slow going one way than the other is all...

[sutty]

Just be certain that you have no mixing enabled in your radio. It must be single servo, direct, or normal, or whatever your radio calls it. That can cause strange issues if it's enabled. I've never seen any of mine go more slowly in only one direction, but it's true that they do react much more slowly on the bench than in the air, as a result of lack of sensor detected movement.

[gaurdian101]

I did the whole set up again the same thing....and thought what the hell lets do it again I'm still new at this fbl thing so I might be doing something wrong I'm sure I was don't know what was wrong but for some reason the last setup everything was working great .....the only thing I don't like


when I turn the tail hard one way bounces back and the other way seems to not bounce back.....I can fly it fine the way it is being still just doing lazy 8 and practicing the side ways and nose in hovering still....but thanks guy

[Highspeed1964]

Originally Posted by 450 3d

...the only thing I don't like


when I turn the tail hard one way bounces back and the other way seems to not bounce back.....I can fly it fine the way it is being still just doing lazy 8 and practicing the side ways and nose in hovering still....but thanks guy

Yah, this is typical at times. Something to do with the feedback loop in software and gain setting, etc. Nothing to worry about. Mine does it too and it flies quite nicely.

Enjoy

Highspeed