I bought a Fusion 50 / Please check setup

[jsonx]

Hello guys,

I found a very good deal and bought an Outrage Fusion 50 from my friend (almost $300). It has all electronics. I will just bind my radio and fly.

The setup is:
Motor: Scorpion HK 4025 - 1100kv
ESC: Hobbywing Platinium V3 100A
Servos: Hitec 5665 x 3, Align DS655 x 1
Blades: 600mm Curtis Youngblood
I will use my Ikon unit.

I am quite new in this hobby and I just inverted my Trex 450. So I am just doing some circles and some flips. I've read that 600mm blades may not good for this 6S setup (for lipos lifecycle). But some pilots say it's fine. As I said I am not flying hard. Will this setup damage to my new PULSE 4500 45C in my flying style?

I hope it's not a problem because i loved this machine.

[raiden83]

Hayirli olsun

[jsonx]

Teşekkürler I will look after your Fusion 50.

[im4711]

If you do not fly hard your 6s setup sounds OK. Only issue with 6s setups might be high current. I tried it and had peaks over 180 Amp. But again - for mild sports flying you should be just fine.

Enjoy your Fusion 50.