need help picking which rx

varacer · 07-15-2012, 07:13 AM

Ok the radio is the 8fg heli is a 700n with vbar. Trying to figure out which rx to use with a gov which the gain has to be on ch7 or 8.

So does that mean the 3 ch sbus rx is out? If I get the 8ch sbus and use the sbus for the vbar can I use the open channels that are sent out over the sbus for something else?

cbane · 07-16-2012, 01:24 PM

I'm not familiar with Vbar, is it possible to customize the channel ordering (both the Futaba CGY-750 and the BeastX can do it)? If it's possible, you can move the governor output to channel 1-3, move whatever was already on that channel to the channel the governor was on, and then set up the Vbar to match.

Another option would be to use the built-in governor in the Vbar, if it works with nitro helis.

Either of these would let you use the R6203SB.

dkpodder · 07-16-2012, 03:12 PM

Quote:

Originally Posted by cbane

I'm not familiar with Vbar, is it possible to customize the channel ordering (both the Futaba CGY-750 and the BeastX can do it)?

Yes, it is possible, no problem.

Quote:

Originally Posted by cbane

Another option would be to use the built-in governor in the Vbar, if it works with nitro helis.

Yes it does, very well in fact.

07-15-2012, 07:13 AM	#1
varacer Registered Users Join Date: Nov 2010 Location: Chesterfield, VA	need help picking which rx Ok the radio is the 8fg heli is a 700n with vbar. Trying to figure out which rx to use with a gov which the gain has to be on ch7 or 8. So does that mean the 3 ch sbus rx is out? If I get the 8ch sbus and use the sbus for the vbar can I use the open channels that are sent out over the sbus for something else?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-16-2012, 01:24 PM	#2
cbane Registered Users Join Date: Mar 2011 Location: Huntsville, AL, USA	I'm not familiar with Vbar, is it possible to customize the channel ordering (both the Futaba CGY-750 and the BeastX can do it)? If it's possible, you can move the governor output to channel 1-3, move whatever was already on that channel to the channel the governor was on, and then set up the Vbar to match. Another option would be to use the built-in governor in the Vbar, if it works with nitro helis. Either of these would let you use the R6203SB.