How to calibration end point with 18MZ

[tommy8275]

Need help how to calibration end point with my 18MZ. I havent flown heli a little over a year and half now im thinking to go back but forgotten how to calibration end point with my 18MZ. Im using CC edge 160HV running Vbar. I did go to End point in my 18MZ but counld not figure out how to make it work I do note in that End ATV have (Limit and travel) have no idea which one should I low to zero . If someone here whos have experience with this radio please provide me info how to calibration.

[Yves128]

Hello Tommy,

In my case I run with the same transmitter as Futaba 18MZ and all the end and subtrim is be part of the gyro function. In my case I run with GPro flybarless sysytem, take a look on you tube?

Yves

[kcordell]

Remove main and tail blades.

Make sure Autorotation in ENABLED in Castle software (if not you will have to repeat this process once Autorotation is enabled)

Set throttle to reverse.

Set your ATV(endpoints) to 50 on both high and low throttle.

Move throttle stick to high position

Connect batteries as if to fly.

Advance ATV (due to throttle being reversed,this will be ATV on low side)up one step at a time until ESC beeps, then add 2 points.

Move throttle stick to low, repeat advance ATV step.

Done!

Also video on this on Castle web site.