START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Spartan RC Spartan RC - Quark, DS760 Gyros and other Spartan RC Electronics Factory Support |
|
LinkBack | Thread Tools | Display Modes |
12-03-2011, 04:34 PM | #1 (permalink) |
Registered Users
Join Date: Apr 2011
|
Trex 250 Quark set up/ esc issue?
I was attempting to set up my new quark on my otherwise stock 250,
and I got halfway through set up to the "adjust low servo endpoint" step. When I got to this point the stock Align esc sounded like it went into its intial tones again and the other servos started glitching? I unplugged it and plugged it back in, repeated the steps and got the same results. I bypassed the gyro all together and it doesnt do it in that configuration. Has anyone else had this problem? I've searched for an answer with no luck. Any ideas? Thanks.
__________________
mcpx / Trex 250 / Trex 500E / Trex 500pro BX/ Trex 700 V2 BX/ Outrage Fusion 50 BX |
Sponsored Links | |||
Advertisement |
|
Thread Tools | |
Display Modes | |
|
|