Scorpion error codes

[doujoh]

I get three beeps after flight with my scorpion 160A .
Anyone know what this means?
This started after switching to vbar control. No such errors before.

[tomkatsix]

Current overload protection if it's 3 red flashing on led

[doujoh]

I have lost the led, so I only hear the beeps.
I made three flights yesterday and the beeps where there after all three of them. The first flight I peaked 189 amps, 162 on the second and 104 on the fourth, so I do not think it is over current. I have flown this heli with the exact same setup except for gyro and vbar control for way more than 100 flights, and never before have I heard these beeps.

[tomkatsix]

I'm going through the same thing
It's di-do-di sounds with 3 red flashing
Only after 2 mins of flight
It show in the book that it COP error
I'm still hunting for the answer

[tomkatsix]

I'm running vbar and vcontrol

[doujoh]

Did you start getting this when changing to vbar control? Have you tried to change the current sensitivity in the scorpion?

[tomkatsix]

I just setup this esc and new motor
To my vcontrol and vbar
I changed the COP to insensitive but still getting the same issue
I'm wondering if its a governor setting
I have not reset governor to the default to get a new base line to start
I just went from castle 160 to this 14s setup

[doujoh]

Do you use vbar governor?

[doujoh]

I just connected my esc to my computer and it has somehow lost all the settings and was set to airplane mode with sensitive over current. I changed it back to heli-no governor and insensitive over current. Will test in a couple of days to see how it works.

[tomkatsix]

Yes I use vbar gov