START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Mikado V-BAR Mikado V-Stabi/V-BAR Flybarless System Software and Hardware Support |
|
LinkBack | Thread Tools | Display Modes |
06-18-2016, 08:50 PM | #1 (permalink) |
Registered Users
Join Date: Jan 2012
|
Anyone running a neo with Hobbywing 200?
Never ran a Hobbywing ESC before but working towards the gov setup on my KSE 700. Looking to use the HW gov. In the set up to calibrate the throttle it says you have to have it in normal mode on a linear throttle curve to set max 100 and min zero values. I understand though from my setup on another Neo, that although you put a linear throttle curve in the transmitter, the neo outputs flat curves only for the flight banks. Any advice on how to calibrate this?
__________________
Lost somewhere down the rabbit hole... Align T-Rex 700DFC, Align T-Rex 700 Tri-Blade Speed, Goblin KSE 700, Goblin 570 12S, Gaui X3, Compass Exo 500 RC Heli Hooligans on facebook |
Sponsored Links | |||
Advertisement |
|
06-18-2016, 11:58 PM | #2 (permalink) |
Registered Users
|
You just use Gov2 screen in the software to stick program ESC, the HWing also works really well with the Neo governor especially with the latest firmware from HWing.
With VBControl you just use the ESC wizard to stick program.
__________________
Henseleit TDR, TDR2, TDF, TDS, TDSF Kontronik, Scorpion ESC, iChargers, VBar, VControl Old hand at Planks Peter |
Thread Tools | |
Display Modes | |
|
|