SK 540 Governor question

[nirtza79]

Hi,
I have (will have tomorrow) the SK 540 and I would like to use the governor, so I will have to buy a phase sensor (http://helidirect.com/rpm-sensor-p-26366.hdx), now just to be on the safe side and not destroying anything I would like to verify.
I have Trex 450 sport V2 with stock motor (align 3400kv) and stock ESC (RCE-BL35P 35A) Can I connect those with no problem or you see something wrong in my setup?

[georgi UK]

=] yes you're good on that gear for gov use, don't forget to enable the software gov before plugging in the sensor, avoids damage.

follow the wizz while usb connected, there is a vid in the sticky, my thread is out-dated but may help??! https://www.helifreak.com/showthread.php?t=296946

[nirtza79]

Thanks georgi ,
Already watched those vids twice now... and read your thread...
Thanks again for the help can't wait to install it all!!

[georgi UK]

=] cool! it's like xmas has arrived a week early for some? is my calender wrong??!

[nirtza79]

No, your calender is good, It is a xmas present from my wife!!

[NewR]

I got few phase sensors comming my way too . Have been using the built-in gov from Kontronik and YGE ESC so curious to see if there is noticeable difference.

[georgi UK]

Originally Posted by nirtza79

No, your calender is good, It is a xmas present from my wife!!

=] well, is her calendar wrong?!

Originally Posted by NewR

I got few phase sensors comming my way too . Have been using the built-in gov from Kontronik and YGE ESC so curious to see if there is noticeable difference.

=] it's proactive, knows where the stick is going and applies more / less rpm's, manages the pitch also if you want, it's different!