NAZA controller update?

[skypup]

The last timeI flew my Naza controller in my flamewheel 450 all was fine. I tried today and the motors would not respond. I decided to plug in to the software and ended up with the new 1.6 update version update. After trying to program, no luck. I'm not sure what might be going on? It seems like the controller isn't receiving programming updates. Any ideas are appreciated. I have not tried to rebind the rx yet. Might that be the issue?

[DesJardins]

After you update to v1.6 you need to redo your set-up top to bottom with Naza assistant

[skypup]

Originally Posted by DesJardins

After you update to v1.6 you need to redo your set-up top to bottom with Naza assistant

Thanks. Thought I had. I'm not sure why it didn't work.

[skypup]

Originally Posted by skypup

Thanks. Thought I had. I'm not sure why it didn't work.

Dumber than a brick, I am. Hadn't flown in a while. Updated controller to newer version and it still wouldn't ramp up. Watched a vid on youtube. I had forgotten about arming the motors using both sticks....test flew and all is well. Thanks.

[DesJardins]

[jasper7821]

Originally Posted by skypup

Dumber than a brick, I am. Hadn't flown in a while. Updated controller to newer version and it still wouldn't ramp up. Watched a vid on youtube. I had forgotten about arming the motors using both sticks....test flew and all is well. Thanks.

I had a brain fart one day too.
I drove about 15 minutes to the park and was going to test out my FPV system for the first time.
Tried for about 15 minutes to get the hexa going and it wouldn't arm.
went home and hooked it up to the computer thinking the NAZA broke somehow.
The set it in the backyard and did the CSC and it started right up.
Can't believe I forgot the CSC, I was so excited to try FPV that I totally forgot to arm the motors.

[skypup]

Originally Posted by jasper7821

I had a brain fart one day too.
I drove about 15 minutes to the park and was going to test out my FPV system for the first time.
Tried for about 15 minutes to get the hexa going and it wouldn't arm.
went home and hooked it up to the computer thinking the NAZA broke somehow.
The set it in the backyard and did the CSC and it started right up.
Can't believe I forgot the CSC, I was so excited to try FPV that I totally forgot to arm the motors.

It's always the little things that seem to get you in this hobby. Getting older doesn't help/ Here's a first vid I took today with my new HD go pro. Just a test.

Goprotest1 (4 min 2 sec)