RF7 reset

[volar]

Hi.
Is there any way of programming the reset button on a dx8 radio, like the one they have on the interlink radio ?
also not able to activate throttle hold, any tips will be appreciated.

[hamstar78]

Try this link. Not sure on reset but my throttle hold works. I hit space bar for reset.

http://www.knifeedge.com/forums/showthread.php?t=30245

[Bubbasanjohn]

Don't think so. Why don't you just spool up the heli on the ground. Hit the p key and set auto reset to 1 second. That way after a crash you will be spooled up and flying instantly. No pushing nothing. . That deserved bacon!

[volar]

Originally Posted by hamstar78

Try this link. Not sure on reset but my throttle hold works. I hit space bar for reset.

http://www.knifeedge.com/forums/showthread.php?t=30245

Thanks for the link, i assigned throttle cut to TH, works ok.

Originally Posted by Bubbasanjohn

Don't think so. Why don't you just spool up the heli on the ground. Hit the p key and set auto reset to 1 second. That way after a crash you will be spooled up and flying instantly. No pushing nothing. . That deserved bacon!

tried with the p key and nothing happened,
however i put keyboard on the floor and reset space bar with my foot for a very quick reset.

[Bubbasanjohn]

Need to go into settings and set auto reset time to x value. P is only to set the reset location of the model. Very useful if you want to restart at a specific altitude and or location. Used this a lot for landing practice on planks. Fly to a good point on my landing run and hit the p key. That way each time I reset I was back ready to start a landing run..... Saves a lot of time.

[volar]

Originally Posted by Bubbasanjohn

Need to go into settings and set auto reset time to x value. P is only to set the reset location of the model. Very useful if you want to restart at a specific altitude and or location. Used this a lot for landing practice on planks. Fly to a good point on my landing run and hit the p key. That way each time I reset I was back ready to start a landing run..... Saves a lot of time.

Got it, finally found it physics tab, works great, Thanks.

[Bubbasanjohn]

Sip

[Starving Bushman]

Originally Posted by Bubbasanjohn

Need to go into settings and set auto reset time to x value.

I can not find this setting. Can anyone point me to where it is?

[volar]

Originally Posted by Starving Bushman

I can not find this setting. Can anyone point me to where it is?

click simulation on top left,
scroll down to settings click and go to graphics click, and open physics on right side there is a auto reset setting change to 1.0 seconds and hit save. done.
good luck.

[Starving Bushman]

Much thanks to you sir.