belt-cp V2/tower pro servos

[greycat]

Will the Tower Pro SG90 servos fit in belt-cp V2 without any modifications and will they work with the stock tx.

[creteus]

They fit, but its tight on the elevator slot. If you take the sticker off the servo it will fit. I actually sanded the servo case down just a hair. They will work fine with the stock RX also.

[sutty]

On a similar note I actually sanded the aperture out a little, just to open it up. It is just a tad, so nothing is compromised. I seem to remember that the one I had trouble with was one of the rear ones, but either way, remove the labels, and a tiny bit of material, and you are good to go.

[brikkman]

is T-Pro Mini Servo Sg-90 9g the same?

http://www.hobbypartz.com/topromisesg9.html

if so, they are $2.77 us
and if they work with belt cp v2 stock tx, I'm getting some since they are so cheap and you guys swear by them... Let me know

[ken234]

i have a question do the arms for the servos work or do you have to use the arms for the tp servos

[creteus]

Originally Posted by brikkman

is T-Pro Mini Servo Sg-90 9g the same?

http://www.hobbypartz.com/topromisesg9.html

if so, they are $2.77 us
and if they work with belt cp v2 stock tx, I'm getting some since they are so cheap and you guys swear by them... Let me know

Its the same. Here in the States Tower Pro servos can not be sold under the "Tower" name. Tower hobbies has the word "Tower" under trademark so anyone selling them in the U.S. has to modify or completly take out the word Tower. Its B.S. but I ran into a problem with Tower Hobbies legal department when I was selling them.

[heliflyer711]

Tower Pro SG90 Servos in USA
2 Well known/used domestic vendors

http://www.helidirect.com/servos-mic..._1352_1354.hdx

https://www.ushobbysupply.com/produc...roducts_id=806