Hp06v2 spare shaft and bearings....where too buy?

[Hoghunter7mm]

Sup everybody? Does anyone know where I can buy a spare shaft and bearings and sizes for my hp06? Seems like the top bearing has some slop and making some noise. Could be from crashes, idk. Thx and happy flying

[dbennettya]

I just use Walkera bearings for the torque tube on the 4G6 and V120D02S series helis that are 1.5 x 4 x 2mm as they are usually left over from maintenance.

I get 1.5mm shaft material from:

http://shop.osorail.com/category.sc?categoryId=30

You have to cut to length and clean the ends up but that is easy to do with a Mototool cutoff wheel.

When replacing the shaft the bell always ends up out of true by a little bit. So I developed a fixture to hold the motor and I use a runout gauge and carefully tweek the bell struts to get as close as possible to zero runout. It isn't easy and you need the right equipment/knowledge to make it work unless you get lucky.

Good Luck, Don

[Hoghunter7mm]

Ok thanks for the info!