Need Help with a YGE esc

[BlazinBones]

I have a YGE 60a I'm installed in my Mini but when I plug power to it, it gives me 6 beeps and then I get the 2 beeps error code (low voltage or something like that). I ran the basic setup as follows for now but still get the 6 beeps for cell count and the 2 beeps error code.

Brake = on
Batt = 2-6s
Timing = 18*
Pw = 9kz
Gov = Off

Now this came out of a P500, could it be possible that it was programmed using a Prog Card and locked to 6 cells? Any suggestions?

[rossk]

What pack are you planning to use?
2 and 3 cells are recognized automatically but 4 and above are set numbers.
If it was used for 6 cells it would be set to 6, resulting in incorrect under voltage detections.
The low voltage error code will play on every startup until it cleared with either 100% throttle during startup or plugging in prog card.
I suggest you get a prog card and see what the settings are, you will prolly want one to set gov store later anyway.

[BlazinBones]

Originally Posted by rossk

What pack are you planning to use?
2 and 3 cells are recognized automatically but 4 and above are set numbers.
If it was used for 6 cells it would be set to 6, resulting in incorrect under voltage detections.
The low voltage error code will play on every startup until it cleared with either 100% throttle during startup or plugging in prog card.
I suggest you get a prog card and see what the settings are, you will prolly want one to set gov store later anyway.

Yes, it plays every time I plug it in. I will definitely run Gov, but will like to sort this first if possible without a card so I can at least fly it till the card gets in. And yes, it was being used on a 500.

[BlazinBones]

So there is no way to factory reset a YGE ESC? Anyone?

[rossk]

Program with the TX to set cell count?
Or does that not work, since it was set with prog card?

[Ecaf]

Have you reviewed documentation here?

http://elektrorc.com/article_info.php?articles_id=2

Also, 6 beeps depending on when they are played is indicative of motor startup failure, and can only be fixed with a reset from a program card.

If this came out of a P500, it is someone may have set it up to be 6S only.

You might also want to bring your question/issue here:

https://www.helifreak.com/forumdisplay.php?f=269

[BlazinBones]

Originally Posted by Ecaf

Have you reviewed documentation here?

http://elektrorc.com/article_info.php?articles_id=2

Also, 6 beeps depending on when they are played is indicative of motor startup failure, and can only be fixed with a reset from a program card.

If this came out of a P500, it is someone may have set it up to be 6S only.

You might also want to bring your question/issue here:

https://www.helifreak.com/forumdisplay.php?f=269

Yes, I have gone through all of it and tried certain suggestions without any luck. Thanks for the referral link, I didn't even know we had a dedicated YGE forum, . I'll post there.