Register Now

3D Dave · 06-21-2015, 03:46 PM

So on my 1st 600SE flight today I had a power loss after a hard collective flip but looks like ESC/VBar went into a low throttle (or no power condition) and had to auto in.

Turns out the one-way failed again. I seem to go through 1 or 2 a season.

Can someone tell me if the new 690sx one way 4876 will work in the standard 600SE with old head/mainshaft, gear and pinion (no counter bearing)?

I thought the new 4876 had a double stacked one-way that is less likely to go out?

I'm just not sure if it will fit.

amphibia · 06-23-2015, 08:15 PM

Similar question here, can the 690 one way bearing 4876 work on logo 600sx v2? Direct swap?

06-21-2015, 03:46 PM	#1 (permalink)
3D Dave Registered Users Join Date: Dec 2007 Location: Chicago Area	690SX One-way (4876) Replacement for 600SE (4067)? So on my 1st 600SE flight today I had a power loss after a hard collective flip but looks like ESC/VBar went into a low throttle (or no power condition) and had to auto in. Turns out the one-way failed again. I seem to go through 1 or 2 a season. Can someone tell me if the new 690sx one way 4876 will work in the standard 600SE with old head/mainshaft, gear and pinion (no counter bearing)? I thought the new 4876 had a double stacked one-way that is less likely to go out? I'm just not sure if it will fit. __________________ Diabolo 700UL / Logo 700 / Oxy 5 / Goblin 500 / Oxy 2 FE / Blade 180CFX / mCPxBL / nano CPS / V-Bar NEO / V-Bar Control / uBrain / DX7 Last edited by 3D Dave; 06-21-2015 at 06:36 PM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-23-2015, 08:15 PM	#2 (permalink)
amphibia Registered Users Join Date: Jan 2014	Similar question here, can the 690 one way bearing 4876 work on logo 600sx v2? Direct swap?

Register Now

Log-in