Switching between FHSS 1 and FHSS 3

[aviansapien]

I was thinking about switching out my FHSS 1 7 channel receiver for a FHSS 3 10 channel receiver. Will all of my adjustments still work? Or will I have to set everything up from scratch?

Thanks in advance.

[Farrell]

The channel assignments and other settings will be the same. All you need to change is the modulation, which is located in the SYSTEM > MODULATION menu. Set it to FH3. If you want to change channel assignments, just go to SYSTEM > CH ASSIGN.

-Farrell

[aviansapien]

Will i have to set all of my servo travel endpoints, ratios, throttle curves and swash settings again? Or are the two types( FHSS 1 and FHSS 3 ) plug and play? Can I just swap one out with the other and bind the new receiver to my transmitter and fly? Or will it be back to setting pitch ranges like it is a first install?


Thanks again everyone.

Bob

[aviansapien]

Anyone switched these types of receivers before using the same model?
Thanks

[TMoore]

Originally Posted by aviansapien

Will i have to set all of my servo travel endpoints, ratios, throttle curves and swash settings again? Or are the two types( FHSS 1 and FHSS 3 ) plug and play? Can I just swap one out with the other and bind the new receiver to my transmitter and fly? Or will it be back to setting pitch ranges like it is a first install?


Thanks again everyone.

Bob

Originally Posted by aviansapien

Anyone switched these types of receivers before using the same model?
Thanks

What did Farrell tell you?

The first sentence in his post says: "The channel assignments and other settings will be the same."

Change the RX's out, bind to the new RX and check your travels and setup. You'll find exactly what Farrell said you would.

TM

[aviansapien]

Thank you! My bad. I appreciate your help. I guess it just seemed too easy.

[TMoore]

It really is easy. You'll love it.