help needed, building my first panthera help !!!

[chino10458]

Hello I just started building my first panthera ok now am trying to understand what it means in main frame assembly there is a note saying bearing blocks123and 4 r the same OK however the orientation of the bearing blocks #2is reversed ??? can some one tell me what this mean??/in the pic i see the bear blocks 134 on them they have these little holes but the number #2 don't have the little holes in the pic it means to turn upside down reversed the little holes face up for 134and 2 the little holes face down help any help will be appreciation really thank you chino I'll be back !

[rotormasher]

Have a look at the latest updated version of the manual, it might be better.

good luck

http://www.genesishobby.com/Support/...2-c44e64fbcc7c

[forvols]

Originally Posted by chino10458

in the pic i see the bear blocks 134 on them they have these little holes but the number #2 don't have the little holes in the pic it means to turn upside down reversed the little holes face up for 134and 2 the little holes face down help any help will be appreciation really thank you chino I'll be back !

You got it Chino10458, main bearing block #2 is turned upside down compared to #1,3, and 4.

Also, remember that #3 and 4 are for the tail drive pinion and have a smaller inner diameter on the bearings

Hope you enjoy the build. Do watch the finless bob video as he steps through the entire build of the Pantera. between the video and the manual, you'll most likely be able to resolve any questions. If not... lots of folks here ready to help

finless build videos are here: https://www.helifreak.com/showthread.php?t=151507

[chino10458]

Hi thank you so so much !!!!!

[chino10458]

thank you very much!!!!

[edhall]

Yea, you will get it fine, it's actually a very straight forward bird to put together.