batt for ta915

[Incarus]

posted this question before. was told to go with hyp 550s for more flight time. is there a cheaper better alternative? the hypes are rated at 25c. I see some with 30c rating but not sure if its just on paper? need somehting that will handle the power of a 915

I have soo many turnigy 300mah 30c packs. maybe i will solder them up to make 1 600 mah 1s bat

a link would help also

thx

[new bee]

Maybe try the lectron pro 600 mah

[Incarus]

never heard of it...anybody have any experience with this.... is the rating accurate and cycle life?

[Chris Gardill]

Can't speak specifically to the 915 but I had a buddy code and opted for the Turnigy Nano-Tech 600 packs that I installed micro deans plugs on for my HP06V2 setup. I have about 60 total flights on the 6 packs I have converted and am using (I bought 10 total from HK). They're a little heavier I think than the Hyperion 550's but seem to have really good pop. I'm getting easy 4 min flights and only running them down to about 30% using an 80% flat governed throttle curve on a flashed XP-12A ESC. Definitely a cheaper option than the Hyperions and they're working well for me thus far.

FWIW, Gens Ace also apparently has a 1s 500mah pack that has just come to market. It's only listed at 20C but people are saying that's a very conservative rating just like most of their other packs. Haven't tried this and am not familiar with how they compare from a cost standpoint, though.

[Incarus]

Thanks. I will look it up.

[Spunjah413]

Hyp 550's or Lectron 600's. The 550's can get hot during an intense 3D session, butt lectrons remain a bit cooler in comparison. The lectrons are also longer.

[tntburnett]

The lectrons are holding up great I got about 40 flights on them and the still doing good .

Be blessed
Isaac

Sent from my DROIDX using Tapatalk 2