 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Avant RC - Mostro & Aurora Avant Mostro, Aurora, Electric eAurora, RigidCore Flybarless Head, Avant EFX and Avant FX Helicopter Support |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
10-06-2014, 11:01 PM
|
#1 (permalink) |
|
Registered Users
Join Date: Nov 2013
Location: Redding Ca
|
Third bearing block
Where do I get the third bearing block for the motor pulley?
|
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
10-07-2014, 06:41 AM
|
#2 (permalink) |
|
Registered Users
|
I don't think it exists yet.
__________________
Samuel Adams field rep Buffalo Wings field rep Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill |
|
|
|
|
10-08-2014, 02:35 AM
|
#3 (permalink) |
|
Registered Users
Thread Starter
Join Date: Nov 2013
Location: Redding Ca
|
It looks like there is holes for it anyone make one? I ran threw a set of motor bearing already about 20 flights
|
|
|
|
|
10-08-2014, 03:50 AM
|
#4 (permalink) | |
|
Registered Users
Join Date: Nov 2012
|
Quote:
__________________
George Mostro 700e - scorpion 4526 - yge 160hv - vbar - rjx servos |
|
|
|
|
|
10-08-2014, 05:12 AM
|
#5 (permalink) |
|
Registered Users
|
+1 on the motor belt being too tight. My motor shaft and bearing needed replacement after about 150 flights. I had used a lever (screwdriver) to tighten the belt and I tightened to way too tight. I think either on the Avant or Carbon extreme web site there is mention of a shaft support bearing in the future.
__________________
Samuel Adams field rep Buffalo Wings field rep Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
