START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Hitec Gyro/Servos Hitec Gyro and Servo Support |
|
LinkBack | Thread Tools | Display Modes |
09-10-2013, 07:09 PM | #1 (permalink) |
Registered Users
Join Date: Jan 2013
|
5065MG Rebuild problem. Looking for some help.
Just rebuilt 2 of those servos. Followed the pictorial instructions on this site. What I have done is contact cleaning, complete gear replacement (all), dielectric grease on all gears and reassembled.
Using the elevator channel on my FBL unit, I plug the servo with horn on, cycle and start moving the sticks. The elevator (rebuilt) servo works and responds fine for about 7 seconds or so and then stops. It is not connected to anything. Second servo does the exact same thing. What could possibly by the problem. I know it has to be in the rebuilt servos. I have checked and swapped servos and channels, and all is good. Thanks for any tips.
__________________
450x-HC3XS ***** DX8 |
Sponsored Links | |||
Advertisement |
|
Thread Tools | |
Display Modes | |
|
|