couple questions?

[keither1984]

ok well first the heli is a 450pro v2 with6s setup and minivbar

1. when doing setup on the cyclic ring value no matter what i type in the box i get no binding also noticed this on my 700 which I swear used to bind at around 85 now i can type 200 and no binding is something wrong or just the max the servos travels.
2. on the 450 when I am doing really fast forward flight say i am going to pull up to do a loop as soon as i give a tiny little bit of elevator it pitches up really hard. what can I adjust in the software for it. it feel like a tail blow out but in the cyclic

[MrMel]

1. Leave at 85, its a dual thing, it wont go higher than your "Cyclic step"
2. It might be that its actually on the level of the heli physics, having cyclic ring high enough is only thing. But it might also be that you have too low values (too much stress on servos)

What is your cyclic step value in the setup?

[keither1984]

what is cyclic step

[bad007]

Originally Posted by keither1984

what is cyclic step

The step during setup where it tips the swash for you to set 8deg. cyclic on the slider and it's wanting between 80 and 110 for opt settings

[keither1984]

have it set at 90