START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Outrage Fusion 50 Outrage Fusion 50 Electric Helicopter Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
02-09-2011, 07:58 AM | #1 (permalink) |
Registered Users
Join Date: Sep 2010
|
Fusion 50 motor support bracket supposed to be threaded on both sides?
ok im putting on my motor support bracket and i noticed the wider half of the bracket has no threads in it for the 8mm long screw like the smaller half does and the manual just shows that you put the 4 screws into the support bracket to secure it... and i don't see anything about using a bolt to hold it on...so im thinking maybe there supposed to be threaded holes on all four instead of just 2 like min are??? but even if it was it wouldn't hold it in place cause the bigger side of the bracket is of the outside of the frame so threads wouldn't do anything...maybe i missed something in manual
__________________
Compass 7HV 9180/9188 Vbar Compass 6HV 9180/9188 Skookum,4025-630KV Compass 6HV Savox/ 9188, Vbar, Fusion 50 9080/9088 Beast X Velocity 50n 9080/9088 VbarSAB Goblin 9180/9188 Kontronik helijive Coming soon |
Sponsored Links | |||
Advertisement |
|
02-09-2011, 08:23 AM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Sep 2010
|
Duh you need to bearing block to complete the assembly of the motor mount..:o
__________________
Compass 7HV 9180/9188 Vbar Compass 6HV 9180/9188 Skookum,4025-630KV Compass 6HV Savox/ 9188, Vbar, Fusion 50 9080/9088 Beast X Velocity 50n 9080/9088 VbarSAB Goblin 9180/9188 Kontronik helijive Coming soon |
Thread Tools | |
Display Modes | |
|
|