Dolphin effect?

[cannon69]

I have a 450 pro. It only happens in idle 2 that is a 100% across.

I don't know if it can be caused by servos that have play in them. I can move the blades up and down about a 1/8 before I hear the gear noise.

I was also told that it could be the gain on the gyro I turned it down 5% and it did get worse. So I went the other way 5% up but haven't had a chance to fly it.

I am a noob so I keep learning things every flights.

[alyon187]

What gyro are you using?

[cannon69]

Originally Posted by alyon187

What gyro are you using?

I am using a Vbar. I found the cause it was a spacer on the feathering shaft one seemed to fatter than the other so there was some play in there.

But I know you use vbar when you use the agility and put it on like 90 for 3d do you mess with the expo on your TX or should that be 0 and let the vbar control it.

[alyon187]

Just depends on what you rather use. Some say that vbars expo feels different than from the tx. I just set my cyclic expo to 0 in the vbar and use it in my tx. For the tail though I use expo in the vbar and non in my tx.

[cannon69]

Originally Posted by alyon187

Just depends on what you rather use. Some say that vbars expo feels different than from the tx. I just set my cyclic expo to 0 in the vbar and use it in my tx. For the tail though I use expo in the vbar and non in my tx.

Thanks for the heads up.

[alyon187]

Sure thing... Just dont double up, meaning not having expo in both tx and vbar. One or the other.

[cannon69]

Originally Posted by alyon187

Sure thing... Just dont double up, meaning not having expo in both tx and vbar. One or the other.

Ya when I first started using it. I found that in the program it will but a value in there. So I just put it at 0.