Neo Nitro gov ar idle help

[Pilot error]

Trying to tune the last few bit on my new n5c.

I haven't got the AR idle to do anything. ..
I'll be running, governor engaged at 1800 or 1900, I'll flip the switch to ar idle and nothing happens, the motor continues to run at the requested rpm of the active bank...

Default ar idle was 40 Or 20 Somewhere around there and I've adjusted It slowly down to 0. Idle is at 18 so I know that the number must be on a different scale.

My question is what numbers are you guys using to get 400-900rpm? Should it be a negative # because it's directly connected to a throttle value? Did I miss a box that needed checking during setup?

Thanks for your help. this is my 4th neo. Works perfect on electrics

[Vinger]

Have you followed the setup here
Normal TX http://www.vstabi.info/en/node/2030
VBC http://www.vstabi.info/en/node/1949

[Pilot error]

Thank you for pointing that out Captain obvious !!

Boy is my face red. That was exactly the issue. I had it all set up perfect in my radio except I had the switch priority wrong in a couple places. Based on this post You all must think I have no idea what I'm doing and have never seen the vbar manual or vstabi website.
But truly the fact is that my 14sh is far more complex a radio than is needed for a vbar. And I like it that way...

Thanks again.