450x Swash type question?

DukeOfLuke · 08-07-2012, 02:46 PM

So i just did a full rebuild of my 450x and became slightly confused when I was re programming my AR7200BX. The 450x manual states to set the transmitter swash type to 90 degrees, however if i am understanding the swash plate correctly the 450x uses a 120 degree swash. Does this mean I should set the AR7200BX to 120 degree and leave the transmitter at 90 degrees as stated in the manual?
Any input would be greatly appreciated. Thank you in advance.

Talesin · 08-07-2012, 03:04 PM

Yes, the BeastX should be set to 120 degree mode, the TX to 90-degree one-servo mode (as all of the CCPM mixing is handled by the BeastX unit).

RodneyK · 08-07-2012, 03:05 PM

Yes, in the transmitter, it should be "1 servo 90 degree" and in the AR7200BX setup, it's 120 degrees in step H (page 12 of the 450X manual).

DukeOfLuke · 08-07-2012, 03:47 PM

Awesome thank you very much for the clarification, I just wanted to be sure.

08-07-2012, 02:46 PM	#1
DukeOfLuke Registered Users Join Date: Apr 2012 Location: CA	450x Swash type question? So i just did a full rebuild of my 450x and became slightly confused when I was re programming my AR7200BX. The 450x manual states to set the transmitter swash type to 90 degrees, however if i am understanding the swash plate correctly the 450x uses a 120 degree swash. Does this mean I should set the AR7200BX to 120 degree and leave the transmitter at 90 degrees as stated in the manual? Any input would be greatly appreciated. Thank you in advance.

08-07-2012, 03:04 PM	#2
Talesin Registered Users My HF Map location Join Date: Jan 2012 Location: Kansas City, MO	Yes, the BeastX should be set to 120 degree mode, the TX to 90-degree one-servo mode (as all of the CCPM mixing is handled by the BeastX unit). __________________ *Blade*: mCX2, mSR, mSRX, Nano-CPX, 2x mCPX (v1), mCPX-BL, 120SR, 450 X Spektrum DX8, DX6i

08-07-2012, 03:05 PM	#3
RodneyK Registered Users Join Date: Mar 2012 Location: Idaho	Yes, in the transmitter, it should be "1 servo 90 degree" and in the AR7200BX setup, it's 120 degrees in step H (page 12 of the 450X manual). __________________ Rodney Synergy E7, Synergy E5, Synergy N5C, Blade 130X

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-07-2012, 03:47 PM	#4
DukeOfLuke Registered Users Thread Starter Join Date: Apr 2012 Location: CA	Awesome thank you very much for the clarification, I just wanted to be sure.