No 8.4V on CC BEC Pro?

[Manzooka]

I just installed one Outrage Torque HV servos in my X5, each of which are spec'd at 5.2-8.4v.

When I try to change the voltage output of the CC BEC Pro I'm only given the option of 8.0 and then 8.5... no 8.4. I've seen other folks list servos running on the BEC Pro's at 8.4, so is there a way to get this value?

[newbheliusr]

Can you select custom?


Sent from my iPhone using Tapatalk

[heraldo]

That 0.1V won't make a difference, just use it


Sent from my iPhone using Tapatalk

[RC Mike]

Nominal voltage for a 2s LiPo is 7.4v so that’s what you should use. The 8.4v gating is peak to cover the first few seconds of a fully charged LiPo pack. I don’t thing that they intended you run at 8.4 volts all the time. That might shorter servo life. As for me I would set the voltage to 7.4.

[Manzooka]

Originally Posted by newbheliusr

Can you select custom?

I just checked for a custom option and didn't see one.

Originally Posted by heraldo

That 0.1V won't make a difference, just use it

Thanks, I figured it wouldn't make a huge diff.

Originally Posted by RC Mike

As for me I would set the voltage to 7.4.

Or 7.5v? As that's the only option? I guess this goes back to what heraldo said above

[heraldo]

If a servo can take a 2S lipo, it's rated to 8.4V. It'll be fine.


Sent from my iPhone using Tapatalk