Spartan quark gyro and Savox 1290mg servo problems

[benjiboy81]

I'm getting a lot of noise from the servo when plugged into the gyro. This is for my HK600GT and not having used either gyro or servo before, it's this right? servo seems to be working Ok and the gyro setup fine.

If I tap the gyro a couple of times the servo noise stops until you give it a rudder input from my dx6i, then the nose starts again. I have the gyro mounted on top of the boom housing using the 3mm foam, metal plate then the 2mm foam pad as the manual says. I'm running a castle talon 90 esc. I get some noise from the servo plugging it in directly to the rx but nowhere near as much.

Any ideas of What's causing this? Bad servo etc?

Cheers Ben

[benjiboy81]

I've sorted it. Tail setup wasn't 100% straight causing the servo to buzz a lot.