E-Flight Blade CP Pro parts

[vapochilled]

Blade CP Pro items for sale
I have two E-Flight 800mAh 3s Lipo's, these have never been deep cycled and have always been charged on a balance charger. Probably no more than 30 cycles each, no damage on them.
Main frame, usual boom re-glued but other than that sound.
Main and Tail motors, used but no more than a dozen flights on them.
Heat sinks for main and tail motors (one brand new in packet for main motor)
3x brand new in packet verticla tail support
1 brand new unopend pack of retaining pins(for the main shaft to head mount, you should change these often!)
1 brand new unopened tail rotor gearbox housing
1 unflown(but not brand new) twin motor tail mount housing, made from some very light metal, Ali maybe, comes with main gear, just mount it and add two tail motors.
tail rotor, used but in very good shape.
a couple of tail drive shafts.
Transmitter, used but in good condition.
3in1 unit, used but again in good shape
RX, used but in great shape

All these parts are spare now I am flying the HDX300, all I kept was the head, and the servo's
So this is all spare.
If you need any single item, make me an offer, or an offer for the lot!
be sensible with the offer and I'll probably accept it, these parts are just sitting about now