MKS DS95 vs DS95A

[bjornal]

After a "small" mishap and sloppyness in servo's I already have, I've decided to replace my servos with MKS servos all over. The tail is obvious with MKS95i, but I'm a little bit confused about cyclic servos. What are the differences with MKS95 and 95A? Or should I just go for 95i for all servos? I'm running with BeastX controller and the standard YGE ESC, but somewhere in the future I'm planning to swap the BeastX with Vbar.

[rossk]

I think you might be confused.
There is no DS95A, there is however DS92A+
The best is DS95, but the value of DS92A+ is a lot better.
There is also DS92, it is not recommended for FBL systems.

I have DS95 on cyclics and DS95i on the tail of both my mini p's and never have I had a servo issue.

http://www.mks-servo.com.tw/photoindex.php?cid=32

[bjornal]

Hi, thanks for a quick answer. Yes, I was confused about which were which, but I probable end up with with DS95's for cyclic and 95i for tail, no reason to not go with the best when i can afford it.

I also see you're using MSH Brain - have you tried it vs BeastX/Vbar?

[rossk]

Originally Posted by bjornal

I also see you're using MSH Brain - have you tried it vs BeastX/Vbar?

Replaced all my vbars for brains, liked them that much

[puttekula]

Cyclic 92A+ , tail 95i and Brain is a lovely combination.

[Cujo22]

Originally Posted by puttekula

Cyclic 92A+ , tail 95i and Brain is a lovely combination.

Same servos here with Beastx, rock solid.


Sent from my iPad using Tapatalk

[aclysma]

I went from hs5065 to ds95s and didn't feel an improvement. So unless you just want the best I'd go with the 92s.

The tail servo though. Uh. Yeah. Amazingly better that the jr 3400 I had before and that is definitely the only thing I will ever install on a 450 tail.