Register Now

machinist1 · 07-17-2012, 06:57 PM

Recently i converted a Blade 350 3D to fbl with a 450 X head and Copter x 3x1000 . I also have the usb cable and the 1.0 software. My maiden flight ended up with wobble not wag, I have tried all the preset options the software has and no luck. Asking for help.

Sent from my DROID BIONIC using Tapatalk 2

MattD7 · 07-17-2012, 10:12 PM

This would probably be better in the Gyro or blade 450 discussion area, but I will take a gander.

My 3x-1000 is working great with EXI D213F servos and they are slightly slower than the DS-76.

Have you tried lowering gain?
What distance are the servo balls at?

I had to move my servo ball in one hole for my 450 pro, when setting collective range for +-12 degrees the sweet spot is a setting of about around 60-70. If it is lower than that the balls are too far out.

07-17-2012, 06:57 PM	#1 (permalink)
machinist1 Registered Users Join Date: Jun 2011	BLADE 450 CONVERTED Blade head and Copter x 3x1000 problems. Recently i converted a Blade 350 3D to fbl with a 450 X head and Copter x 3x1000 . I also have the usb cable and the 1.0 software. My maiden flight ended up with wobble not wag, I have tried all the preset options the software has and no luck. Asking for help. Sent from my DROID BIONIC using Tapatalk 2

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-17-2012, 10:12 PM	#2 (permalink)
MattD7 Registered Users My HF Map location Join Date: May 2011 Location: Clearfield, UT	This would probably be better in the Gyro or blade 450 discussion area, but I will take a gander. My 3x-1000 is working great with EXI D213F servos and they are slightly slower than the DS-76. Have you tried lowering gain? What distance are the servo balls at? I had to move my servo ball in one hole for my 450 pro, when setting collective range for +-12 degrees the sweet spot is a setting of about around 60-70. If it is lower than that the balls are too far out.

Register Now

Log-in