Register Now

FireDoug · 05-12-2012, 01:28 AM

So I setup my fleet on my new DX8 tonight. I had the DX6i sitting next to me and I was extracting servo reversal, swashmix, D/R my throttle cures out of two CP helis.

Well I was surprised after I completed binding the DX8 to the helis the each of them had a screwed up swashplate movement. Did not recognize a pattern but both heli's had to have at least on servo reversed and one swashmix reversed.

Did not expect this.... Why does Spectrum have different setup parameters?

Best Regards
Doug

aerocal · 05-12-2012, 06:18 PM

There are a few parameters that may be different.Its just how it comes out to make all the progrograming right.The best thing to do is just set the model up from scratch with a new radio.

Slyster · 05-12-2012, 11:22 PM

always set up from scratch! i found this out a few years back upgrading from a DX6i to a DX7. They are just not the same radios.

05-12-2012, 01:28 AM	#1 (permalink)
FireDoug Registered Users My HF Map location Join Date: Jan 2012	Huh? DX8 Setup not transferal from DX6i So I setup my fleet on my new DX8 tonight. I had the DX6i sitting next to me and I was extracting servo reversal, swashmix, D/R my throttle cures out of two CP helis. Well I was surprised after I completed binding the DX8 to the helis the each of them had a screwed up swashplate movement. Did not recognize a pattern but both heli's had to have at least on servo reversed and one swashmix reversed. Did not expect this.... Why does Spectrum have different setup parameters? Best Regards Doug __________________ I am becoming a better Heli Mechanic than Pilot. Blade CX2, HBFPV2, Blade mSRx, Trex 450 Pro FBL, Blade mCPx, Blade 400 FBL, Blade 450 3D FBL , NANO CPX, 130X - DX8

05-12-2012, 06:18 PM	#2 (permalink)
aerocal Registered Users Join Date: Jun 2008	There are a few parameters that may be different.Its just how it comes out to make all the progrograming right.The best thing to do is just set the model up from scratch with a new radio. __________________ Too many helis & Too many planks Lots of DX radios & A couple Futaba 72mhz radios AMA member & Full scale plank driver HELIFREAK !!!

05-12-2012, 11:22 PM	#3 (permalink)
Slyster Registered Users My HF Map location Join Date: May 2008	always set up from scratch! i found this out a few years back upgrading from a DX6i to a DX7. They are just not the same radios. __________________ "It's not just a hobby... it's a lifestyle" - Pete ϟ MINNESOTA! Goblin 500 + 700 / SK540 / Jives / DX8 / Quantum / RJX servos / 306b / Deep cycles

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in