START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
bavarianDEMON/HeliCommand Factory Sponsored Bavarian DEMON and HeliCommand Support |
|
LinkBack | Thread Tools | Display Modes |
05-21-2012, 07:45 PM | #1 (permalink) |
Registered Users
Join Date: Jun 2009
|
HC3sx registration time?
When I say registration I'm referring to the things machines controlled by computers do at start up before they are ready to run.
When plugging in the flight packs...... Is there a registration time that must be observed before using horizon mode. Does the heli need to be on a level surface during registration?
__________________
600 Align Futaba 14SG And about $7000 in assorted things. |
Sponsored Links | |||
Advertisement |
|
05-21-2012, 10:18 PM | #2 (permalink) | |
Registered Users
Join Date: Jan 2012
|
Quote:
|
|
05-21-2012, 10:39 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2009
|
What page of the manual? I looked but didn't see it.
So basically the copter needs a level surface with no movement for 30 seconds after power up?
__________________
600 Align Futaba 14SG And about $7000 in assorted things. |
05-21-2012, 11:25 PM | #4 (permalink) | |
Registered Users
Join Date: Jan 2012
|
Quote:
Oh ok, maybe i read it somewhere, Anyway all i have ever done is "level surface with no movement for 30 seconds after power up" And i have never had a problem .. Maybe i read it in the forums somewhere, in any case i know it's the right info .. Cheers Mark |
|
05-22-2012, 03:32 AM | #5 (permalink) |
Registered Users
Join Date: Dec 2010
|
This part after plugging in the battery is called "initialisation" And this takes about 4 secs until the servos are responding.
Nothing else you need for the horizon to wait for. A flat surface of course is always helpful, but anyway the horizon will set itself up correct in flight, even if the heli is a but leaning to one side when initialising. Joachim
__________________
Joachim CAPTRON Electronic GmbH - bavarianDEMON Support, Product & Sales Manager - |
05-22-2012, 10:54 AM | #6 (permalink) | |
Registered Users
Join Date: Jan 2012
|
Quote:
Thanks for clearing that up, good info to know :-) |
|
Thread Tools | |
Display Modes | |
|
|