Register Now

CR@$H · 01-19-2015, 08:48 PM

Hello all,

I just purchased my first heli and I probably went cheap but after research this one seemed to fit me for now. I "learned" how to fly with a syma 107G and that was fairly complicated for a couple days and I loved it. I now wanted to get into 3D flight and purchased my WL Toys V922. I am barely able to get it off the ground in the house because of obstacles and have consequently crashed it. One of the two wires that feed the back rotor motor has been pulled out of the connector that attaches to the board. I pulled out the pin and tried to reconnect but to no avail and now I have broken the tiny pin and need a replacement. Do you know where I might go to purchase some of these tiny pins? The connector only feeds two wires. I was looking at the Walkera mini cp and I see a full tail assembly that looks similar to mine...does anyone know if this copter converts to mine?

sdunne · 01-20-2015, 02:25 AM

Put up a photo of what your looking for, I'm sure there will be some suggestions.

CR@$H · 01-20-2015, 11:47 PM

***Update****

I found the wire that I was looking for and it was hard to find but on Banggood.com. Here is the link for anyone that the tail has come off and now the wire is out. It looks as this is a universal part that works across a lot of models and manufacturers.

http://www.banggood.com/Wholesale-Hi...e-p-57516.html

01-19-2015, 08:48 PM	#1 (permalink)
CR@$H Registered Users Join Date: Jan 2015	WL Toys v922 Hello all, I just purchased my first heli and I probably went cheap but after research this one seemed to fit me for now. I "learned" how to fly with a syma 107G and that was fairly complicated for a couple days and I loved it. I now wanted to get into 3D flight and purchased my WL Toys V922. I am barely able to get it off the ground in the house because of obstacles and have consequently crashed it. One of the two wires that feed the back rotor motor has been pulled out of the connector that attaches to the board. I pulled out the pin and tried to reconnect but to no avail and now I have broken the tiny pin and need a replacement. Do you know where I might go to purchase some of these tiny pins? The connector only feeds two wires. I was looking at the Walkera mini cp and I see a full tail assembly that looks similar to mine...does anyone know if this copter converts to mine?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

01-20-2015, 02:25 AM	#2 (permalink)
sdunne Registered Users Join Date: Feb 2011	Put up a photo of what your looking for, I'm sure there will be some suggestions.

01-20-2015, 11:47 PM	#3 (permalink)
CR@$H Registered Users Thread Starter Join Date: Jan 2015	*Update** I found the wire that I was looking for and it was hard to find but on Banggood.com. Here is the link for anyone that the tail has come off and now the wire is out. It looks as this is a universal part that works across a lot of models and manufacturers. http://www.banggood.com/Wholesale-Hi...e-p-57516.html

Register Now

Log-in