naza x connections?

[crazycraig]

Ok, this question may have been asked before but I can't find it. What are the x1,x2,and x3 connections on the naza for? I think the x1 is for gimbal control when using camera mounts, but what about x2 and x3.

Again sorry if this has been already answered; I googled but couldn't find anything.


Craig

[02deuce]

See owners manual.
http://download.dji-innovations.com/..._Manual_en.pdf

F1 & F2 are for gimbal control.

X3 is connected to the VU

X2 can be used for IOC or as and open channel for things like remote gain setting etc.
X1 is a open channel for things like remote gain setting etc.

[crazycraig]

Originally Posted by 02deuce

See owners manual.
http://download.dji-innovations.com/..._Manual_en.pdf

F1 & F2 are for gimbal control.

X3 is connected to the VU

X2 can be used for IOC or as and open channel for things like remote gain setting etc.
X1 is a open channel for things like remote gain setting etc.

Thank you

what will the remote gain actually do? Again sorry for stupid questions (with a three month old I only have a few hours a week to work on this.)

[Altimat]

It will allow you to assign your gain(s) to one or two knobs on your TX. This can be helpful during initial tuning flights allowing you to become familiar with how the gains affect the craft and where you want them to be.

If you are unfamiliar with MRs and/or gains landing and connecting to the assistant, and then taking off to test new settings only slightly changed can be a difficult way to go about it.

You can also use one knob/channel for camera pitch and one for gains.