START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
MSH Protos MSH Protos Helicopter Support Forum |
|
LinkBack | Thread Tools | Display Modes |
07-16-2012, 11:54 AM | #1 (permalink) |
Registered Users
Join Date: Nov 2008
|
Are these settings too high?
Been flying my protos 500 a lot lately. It's the only heli in my fleet right now. During the build, I had a lot of problems, but now that everything is done and set up I just love this thing. Really low maintenance heli. Anyways, here's my question:
I have the 7200bx installed. My tx gain is at 75-80. Parameter D is at default. The question I have is regarding the 3 pots on the fbl unit itself. Pot 1 is turned all the way up; I don't notice any bad tendencies, but what should I be looking for? Pot 2 is turned all the way up also; the heli was a little slow to respond but now it's much better. Are these settings way too high? My heli is locked in more than anything I've ever flown. Just wondering if too high of these settings are bad.
__________________
God made firefighters so cops could have heroes too. Firefighters: Chicks dig us and cops want to be like us, because we find them hot and leave them wet. |
Sponsored Links | |||
Advertisement |
|
07-16-2012, 04:56 PM | #2 (permalink) |
Registered Users
|
WOW, With my BX, Param D is low, about 60% gain on DX6i, Pots 1-2 are a half a click above center and 3 is center. Running TX mode, End Points 120%, D/R 97% Expo 26%
__________________
Dan Pesonen FBL, Don't think about it, DO IT. mCX2, nCPX, mCP X, Blade 400, MSH PRÔTOS, T-700N "Tri-Flow" I put that S*** on everything!" |
Thread Tools | |
Display Modes | |
|
|