TDR II counter bearing

[Joeribar]

Hello everyone,

I've installed my new servos and the belt fits perfect on the gear of the elevator servo but the space between the gear and the counter bearing is more after putting in the screw from the frame to the counter bearing then before with my other servo.

Is this a problem?



Verstuurd vanaf mijn SM-N910F met Tapatalk

[Vinger]

Anual on page 45

Measure the distance between the frame bottom and the top side of the belt disc. It should account to 50mm +/- 1mm. If the distance is less that 48mm, you can adjust with the 1mm plastic supports between the frame and chassis panel. Now slide the pre-assembled counter bearing onto the projecting shaft of the belt disc. The complete unit including support adjustments and counter bearing should be less than 58mm (left drawing). This is required to insert the unit from the bottom between the panels in the next assembly step. Please also align the servo frame mounts so that they are parallel to each other and to the servo housing.

Jan gives minimum and maximum dimensions, adhere to his measurements and adjust servo with the black spacer supplied in the kit. There is a bit of tension on the pulley and if only seated halfway into the bearing it might cause the bearing to fail over time.

[Joeribar]

I've also asked Timo and he says it isn't a problem like I have it know



Verstuurd vanaf mijn SM-N910F met Tapatalk