START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Ufly Walkera Ufly Helicopter Support |
|
LinkBack | Thread Tools | Display Modes |
03-26-2010, 11:57 AM | #1 (permalink) |
Registered Users
Join Date: Mar 2010
|
Rx2428 and Digital tail servo Conversion
Hey,i just did the conversion without the turboace motor and the tail is awesome with the digital servo and avcs HH gyro,but i do notice the extent needs to be turned all the way up and seems slower than stock,not terrible but to me a little slower.How can i increase cyclic speed.Will 2 more digital servos do it?Is it faster when the ball link rod is closer or farther from servo horn?any help appreciated.Any recommendations on digital servos for ufly ! Thanx
|
Sponsored Links | |||
Advertisement |
|
03-26-2010, 12:09 PM | #2 (permalink) | |
Registered Users
|
Quote:
http://www.rchobbyhelicopter.com/sto...ser2=RC_Servos
__________________
Beating the air into submission!!!!
|
|
03-26-2010, 12:31 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Mar 2010
|
Digital servos
Thanks,since im not the sharpest tool in the shed,is the speed faster if the number is higher or lower..0.16 or 0.13sec.Guess i would have to also scrap the digital one that came with conversion and get 3 that match.
|
03-26-2010, 05:04 PM | #4 (permalink) |
Registered Users
|
No... you should be fine on the tail servo. I guess if you just wanted 3 servos that match you could change it out. As for the speed of the servo the actual number is the correct speed so if you have a 0.16 and a 0.13 The faster servo will be the one with the lowest number.
__________________
Beating the air into submission!!!!
|
Thread Tools | |
Display Modes | |
|
|