Register Now

Stuarty · 04-11-2013, 03:25 PM

Hi all

I've just moved a trex700nitro onto futaba and and would like to know, do I perform the exact same start up for trim flight on nitro as I would do on electric?

Throttle stick up, throttle hold on
Power up Heli
Get double twitch

Now on electric you leave at half stick and switch off throttle hold.

How do you do it on a Nitro.

Kind regards
Stuart

rctintin · 04-20-2013, 02:28 AM

^^^^Same question please^^^^

sagiadir · 04-21-2013, 06:55 PM

from what I told the trim should be in 0 deg of pitch so
if you set you pitch curve to be at 0 in low stick utill middle its ok.
does any one know different ???

Glenn Goodlett · 04-24-2013, 10:08 AM

I have always switched it on via the software and then switched it off via the software after the flight. Did not know there was another way until now.

04-11-2013, 03:25 PM	#1 (permalink)
Stuarty Registered Users Join Date: Nov 2009	Trim flight with nitro??? Hi all I've just moved a trex700nitro onto futaba and and would like to know, do I perform the exact same start up for trim flight on nitro as I would do on electric? Throttle stick up, throttle hold on Power up Heli Get double twitch Now on electric you leave at half stick and switch off throttle hold. How do you do it on a Nitro. Kind regards Stuart __________________ Logo Xxtreme 700, Kosmik/Scorpion, HC3-SX, 451/251, Edge Logo 600sx, Kontronik, vBar, 451/251, Edge Logo 500se, Kontronik/Scorpion, HC3-SX, 451/251, Edge Avant Ultimate Ys91SRS/Hatori, vBar, 451/251, Edge

04-20-2013, 02:28 AM	#2 (permalink)
rctintin Registered Users Join Date: Jul 2009	^^^^Same question please^^^^ __________________ TDRx2, Synergy N7/E7se/N5cTT, Align 450L/550/700e/700n, Gaui NX7/NX4, , Goblin 700/Black Nitro, Futaba 18MZ/ V-Control All on V-Bar's and S-Bus. #0095

04-21-2013, 06:55 PM	#3 (permalink)
sagiadir Registered Users Join Date: Jun 2009	from what I told the trim should be in 0 deg of pitch so if you set you pitch curve to be at 0 in low stick utill middle its ok. does any one know different ??? __________________ Dx 8 T-Rex 700N LE *Ikon FBL* *Ys 120Sr*

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-24-2013, 10:08 AM	#4 (permalink)
Glenn Goodlett Registered Users Join Date: Feb 2009 Location: Ridgecrest, CA	I have always switched it on via the software and then switched it off via the software after the flight. Did not know there was another way until now.

Register Now

Log-in