Futaba t8fg and gains

[devilfish]

I have tail gain on "gear" channel, and cyclic on aux 2, both controll by the "se" switch on my radio, so they follow my idle-up change.
So far so good.

I have adjusted the atv on the gear channel and aux 2 channel so in normal mode I have 50% tail and 50% cyclic gain, in bank1.

Then I go to idle up 1 and bank 2.
Now I can use the gyro menu to change the tail gain to what i like in the gyro menu, BUT the aux 2 gain ( that is channel 7 ) is now going to "off", position and now I cant adjust the cyclic gain. And im stuck at 15% on cyclic gain in the sk540 software.

Can this be solved?

Thanks

[JTAnimal]

I may be off base but you could lock the gain amount for bank 2 cyclic. I dont have mine set up like yours i use a seperate switch for the cyclic and gain, i dont have it set up to change on the idleup switch. i can change the gain amount in the endpoints area of the TX

[devilfish]

I solved it.

I updated my t8fg to t8fg super. And now I can use the aux2 in the gyro menu together with the gear channel.
So im fine now

Thanks