Pyro motor service in USA?

[seefest]

Anybody have the Kontronik Pyro motor service contact in the US? I had it, but misplaced it. Thanks in advance.

[waxman]

I would say it would be kontronik USA or heli direct.

[abanihani]

Send a pm to charles Anderson under kontronikusa. He is a great person and has helped me alot.

[Wh1teAfr1can]

Greg Alderman at Helidirect is handling motor bearing and shaft replacements. so shoot him a PM, Charles can also direct your request to Greg.

[KONTRONIK USA]

Kontronik USA Service
PO Box 5
Oakville, IN *47367

Please complete the repair form on www.kontronik.com website and ship the motor to the address listed above. When the repair is completed Greg will contact you.

Charles

[Freeskiken]

Hi, I bought a used Jive 120 and it looks a little rough. The case close to where the slave cable plugs in is damaged. It looks cosmetic but I am worried it may not work correctly. Is it Heli Direct that we send them to for service ? I am tempted to buys new one anyway. But I guess I would have to send it in and get it tested before I would feel good about reselling it.

[KONTRONIK USA]

Helidirect is a KONTRONIK dealer, if you purchase an item from there you may consult with them if you have problems with your purchased item. As you purchased your item used, it would have to go to Germany for any repairs.

If your HELI JIVE 120 is working fine, and the damage is truly cosmetic I would see no reason to send. If you choose to send it in for a damaged case, this must go to Germany.

[Freeskiken]

Originally Posted by KONTRONIK USA

Helidirect is a KONTRONIK dealer, if you purchase an item from there you may consult with them if you have problems with your purchased item. As you purchased your item used, it would have to go to Germany for any repairs.

If your HELI JIVE 120 is working fine, and the damage is truly cosmetic I would see no reason to send. If you choose to send it in for a damaged case, this must go to Germany.

Thank you for the reply. I would just like to be sure. I am not at the point where I am assembling the Heli I bought it for yet so I think I should send it in for testing. Thanks again.

[Freeskiken]

I packaged it up. Filled out the form. Enclosed the form in the box. Marked the box return for repair item. I am sending to Germany.

I was looking at the positive wire and it has corrosion on the end. I tried to scrape it off and it was still there. So I cut a little off, then a little more. I cut it a few times. The wire looks old? Why would it still be corroded? I cut about a 1/4" off. Didn't want to cut too much off because they are already shorter. Hopefully it will be OK.

[Freeskiken]

Wow it looks like by tracking it has been sitting in Germany since May 21 ? Hopefully it gets to Kontronik. I shipped it May 15. On the tracking site is just says arrived in International Logistics Center.