Re-built V120D02s

[omar ariffin]

Hi All
I just recied upgrade part from Microheli Aluminium Frame / Metal Head set. After complete installation will
1. Align the Servo Horn
2. Level the swash plate
3. Reset the Devo7E to factory setting.

My concern now if i need to do all the above item should I switch from WK to ADJ
I' new & to lern from fresh.

Regards
Omar

[jml79]

The ADJ setting is so you can centre your servos and level the swash. It turns of the gyros to stop the heli from moving the swash while you're working on it. Just make sure you put it back to WK before flying.

[omar ariffin]

Hi jml79
Thanks for your advice.

Regards
Omar

[omar ariffin]

After reset the Devo 7E & I tries to set the thr. travel.
At o stick the motor still not stop & spining slowly. Any advice on the right method to set the throttle travel?

Regards
Omar

[jml79]

I have had a similar issue. Did you have Trottle Hold on when you plugged the battery into the helicopter? The ESC sets the zero throttle when it's powered up. If your throttle hold is set to -105 and is on when you power up the heli, the ESC sees -105 as the low point. Then you flip off the throttle hold the heli sees -100 and starts spinning because thats not the low point.

To solve this I have all of my throttle holds set to -100 instead of the default -105. Let me know if this is the issue.

[omar ariffin]

After 3 days the V120 fly smoothly..& plan to buy v450D01.
I still camparing between this V450D01 with Trex450 but he I like the Walker 6-axis gyro capability.

Regards
Omar