Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > R/C Electronics Support > Spartan RC


Spartan RC Spartan RC - Quark, DS760 Gyros and other Spartan RC Electronics Factory Support


Reply
 
LinkBack Thread Tools Display Modes
Old 08-14-2016, 03:04 PM   #21 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Ive gone abit backwards today. I did a trim flight and then flew it and it felt abit too fast so i put the agility down and did another trim flight and then the tail was not crisp. When I stop the tail it continues to turn a little then stops.

Do i need to move the tail when i do a trim flight?

Whats the default pitch up comp? Im going to put that back to default and then tune everything again in order
Dukesy500 is offline        Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 08-14-2016, 03:18 PM   #22 (permalink)
Registered Users
 
Posts: 1,388
 

Join Date: Dec 2013
Default

If you press the + and - button at the same time on the data pod it sets default. Pitch up comp doesn't affect tail stops but the trim flight does. Redo the trim flight in zero wind if possible about 8 ft above the ground.

Then adjust tail stop gains to get the tail to stop better. If the tail continues to turn then increase tail stop gain. If you are getting a bounce back then decrease
dominator is offline        Reply With Quote Quick reply to this message
Old 08-14-2016, 04:51 PM   #23 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Thanks mate. Ive lost myself abit with it but going to start again.
I put the trim flight on but then moved the heli to the flight line. Could this of messed it up

Should I move the tail at all during the trim flight?
Dukesy500 is offline        Reply With Quote Quick reply to this message
Old 08-14-2016, 05:32 PM   #24 (permalink)
Registered Users
 
Posts: 1,388
 

Join Date: Dec 2013
Default

Set the heli down where you are going to take off then start the trim flight. Bring it to a hover and try to not touch the sticks. When the heli climbs the trim flight is complete
dominator is offline        Reply With Quote Quick reply to this message
Old 08-15-2016, 06:59 AM   #25 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Do you think i should just load the heli wizard and start again?
Dukesy500 is offline        Reply With Quote Quick reply to this message
Old 08-15-2016, 07:02 AM   #26 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Also, if i do a trim flight and then want to change the agility. Do i have to do another trim flight?

Sorry for so maby questions
Dukesy500 is offline        Reply With Quote Quick reply to this message
Old 08-15-2016, 07:20 AM   #27 (permalink)
Registered Users
 
Posts: 1,388
 

Join Date: Dec 2013
Default

No need to load the wizard again. The trim flight basically just sets the tail to the optimal center position during a hover. So you only need to do it correctly one time.

After that you can adjust anything and it won't affect the trim flight.
dominator is offline        Reply With Quote Quick reply to this message
Old 08-15-2016, 02:59 PM   #28 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Ok perfect.

Thanks mate ill give it another try
Dukesy500 is offline        Reply With Quote Quick reply to this message
Old 09-16-2016, 07:27 AM   #29 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Hi all.
So I put the pitch up comp back to 60.
Did another trim flight correctly.
Been tuning the roll rate and upping the main gain. Feeling good now and getting confident.
Still tuning the main gain untill it wobbles

Heres a video so far

Hell yeah Goblin 380! (6 min 45 sec)
Dukesy500 is offline        Reply With Quote Quick reply to this message
Old 09-16-2016, 07:36 AM   #30 (permalink)
Registered Users
 
Posts: 1,388
 

Join Date: Dec 2013
Default

Nice flying! Looks like it hold a nice straight line in speed runs. The end of your video made me
dominator is offline        Reply With Quote Quick reply to this message
Old 09-17-2016, 02:14 PM   #31 (permalink)
Registered Users
Thread Starter Thread Starter
 

Join Date: Jan 2009
Default

Thanks mate Haha gdgd glad you got a laugh out of it. My bros got a 380 but he hasnt built it yet and my mate was supposed to book the same week off work but didnt and its normally rubbish weather here but it was blue sky and hot all week haha so i was rubbing it right in everyday lol.
The weather changed to crap now but ive really got that flying itch!
Hopefully be able to go tomorrow

Last edited by Dukesy500; 09-18-2016 at 02:52 PM..
Dukesy500 is offline        Reply With Quote Quick reply to this message
Reply




Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the HeliFreak forums, you must first register.
Please enter your desired user name, your REAL and WORKING email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself. Use a real email address or you will not be granted access to the site. Thank you.
Email Address:
Location
Where do you live? ie: Country, State, City or General Geographic Location please.
Name and Lastname
Enter name and last name here. (This information is not shown to the general public. Optional)
Helicopter #1
Enter Helicopter #1 type and equipment.
Helicopter #2
Enter Helicopter #2 type and equipment.
Helicopter #3
Enter Helicopter #3 type and equipment.
Helicopter #4
Enter Helicopter #4 type and equipment.

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1