Register Now

Antsis · 04-07-2013, 07:38 PM

Hi All

I acquired a complete Trex 600 ESP with the intention of installing it into a scale body. I have found the frames hit the roof of the cabin and I found out that another member of my club used HK600 frames as they are slightly lower.

I would like to know if anyone can confirm this and whether or not the torque tube/boom housing fixing screws are in the same position as the belt housing. I would prefer to buy just a set of frames instead of a complete kit, plus I want to keep the torque tube.

Mike A. · 04-14-2013, 07:59 PM

You'll probably get more of a response if you post this in the 600 section, not the Pro sub-forum. Good luck

04-07-2013, 07:38 PM	#1 (permalink)
Antsis Registered Users My HF Map location Join Date: May 2006	Swapping T600ESP bits to HK600 frames Hi All I acquired a complete Trex 600 ESP with the intention of installing it into a scale body. I have found the frames hit the roof of the cabin and I found out that another member of my club used HK600 frames as they are slightly lower. I would like to know if anyone can confirm this and whether or not the torque tube/boom housing fixing screws are in the same position as the belt housing. I would prefer to buy just a set of frames instead of a complete kit, plus I want to keep the torque tube. __________________ Ant

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-14-2013, 07:59 PM	#2 (permalink)
Mike A. Registered Users My HF Map location Join Date: Feb 2011	You'll probably get more of a response if you post this in the 600 section, not the Pro sub-forum. Good luck

Register Now

Log-in