Tail motor with factory brushless

[Markkeri109]

Does anybody know what is this best tail motor to use with the new factory brushless motor. thanks. Also, best tail length 115mm for tail length?

[JonJet]

I have had no good luck with doing the HH main motor upgrade...the tail on Mine is a stock mCPX (BLH3602) with a Lynx 42mm tail rotor...

My opinion? The HH upgrade is like a Band-Aid on a broken leg...a cover up, not a cure

I've gone Dbl Bl on My other Nano, and it's so solid it isn't funny...

No bog, no kick, no problems

[NCcraig]

The stock nano tail boom length, 107mm. with the stock tail motor, works on a mild motor so I would think it do the same for the BL motor HH came out. A BL tail is nice but not necessary. I use a 125mm tail boom with the stock tail motor, i.e. mCPX tail boom length, on a wild motor setup. I would suggest a BL tail on a wild motor but that is my preference and again is not necessary.

[Markkeri109]

THX!

[JackG79]

Originally Posted by Markkeri109

Does anybody know what is this best tail motor to use with the new factory brushless motor. thanks. Also, best tail length 115mm for tail length?

One thing I did was to remove the main shaft bearings and either replace them, or make sure that they are cleaned with parts cleaner, then put a light coating of light oil on them and replace them. The less friction around the central pivot point, the less the tail rotor has to over-come.

I had good luck with the "Xtreme 7.00mm Turbo Tail".... I took the rotor off it and used a Lynx 42mm rotor. I have very little tail sway during hard pitch pumps.

I've also go the HH Factory Brushless upgrade, and while it isn't as strong as some of radical brushless upgrades available on the market, it is def. a marked improvement. And the motor will last a lot longer than stock... (that was my reason for buying it).