 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Mikado Logo 700 Xxtreme Mikado Logo 700 Xxtreme Helicopters Discussion |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
01-13-2015, 08:25 PM
|
#1 (permalink) |
|
Registered Users
Join Date: May 2013
Location: mass
|
motor shaft length
What is the minimum shaft length needed for the 700? The stock scorpion says its shaft is 60mm long. Im looking at a motor that has 52mm long. Is this usable?
__________________
helifreak member since 2003 south of boston Last edited by iheliflyer; 01-13-2015 at 08:43 PM.. Reason: spelling |
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
01-13-2015, 10:13 PM
|
#2 (permalink) |
|
Registered Users
Thread Starter
Join Date: May 2013
Location: mass
|
length
Basically what im asking is will 52 mm reach the second bearing support?
__________________
helifreak member since 2003 south of boston |
|
|
|
|
01-14-2015, 02:12 PM
|
#3 (permalink) |
|
Registered Users
Join Date: Jul 2005
|
I am installing my motor tonight. I will take measurement for you.
__________________
Ryan Mikado USA, Kontronik, Opti-Power, MKS Servos, VTX |
|
|
|
|
01-14-2015, 02:16 PM
|
#4 (permalink) |
|
Registered Users
Thread Starter
Join Date: May 2013
Location: mass
|
length
Awesome. Thanks.
__________________
helifreak member since 2003 south of boston |
|
|
|
|
01-15-2015, 09:25 AM
|
#5 (permalink) |
|
Registered Users
Join Date: Jul 2005
|
I just measured and from the surface the motor mounts to to the bottom of the inner race of the bearing is around 52mm.
Sounds like your motor should be perfect.
__________________
Ryan Mikado USA, Kontronik, Opti-Power, MKS Servos, VTX |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
