START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Rotor Blades R/C Helicopter Rotor Blade Discussions |
|
LinkBack | Thread Tools | Display Modes |
08-31-2011, 11:22 AM | #1 (permalink) |
Registered Users
Join Date: Nov 2004
|
DIY night tail blades 95mm
Wondering if anyone else has made their own night tail blades...
I have started to build a set, pretty much wired up, but still am a little concerned over the high tail RPM and extra weight (1.5g) offset from the center of the blade. This is on a Logo 600 tail with 2 radial bearings and 1 thrust... I don't think the weight itself is an issue, more the offset. I do use high strength 3M tape to hold the cell down, then use shrink to press it to the blade so it won't shoot out as I do with my mains. Anyone with experiences?
__________________
LAHeli, MSH, YGE - ElektroRC.com |
Sponsored Links | |||
Advertisement |
|
Thread Tools | |
Display Modes | |
|
|