START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Castle Creations ESC and Software Castle Creations ESC Software and Hardware Support |
|
LinkBack | Thread Tools | Display Modes |
10-20-2014, 05:26 AM | #1 (permalink) |
Registered Users
Join Date: Apr 2013
|
End point setup on a Walkera Devo 10
So I have seen how you calibrate a castle ESC by reducing the throttle end points and then increasing them until the ESC signals.
I fly with a Devo 10, stock firmware. There doesn't seem to be any adjustments under "end points", but there is a "travel adjustment" for each individual channel, throttle included. You can change lower and upper percentages. I suppose the percentage you set scales the throw on each side. I.e. going from 100% to 50% on the upper end of the throttle takes a 100% throttle signal to a (50 + 0.5 * 50)% = 75% throttle signal. Is this equivalent to an "end point" adjustment? |
Sponsored Links | |||
Advertisement |
|
10-20-2014, 09:56 AM | #2 (permalink) |
Registered Users
Join Date: Feb 2012
Location: Grande Prairie, Alberta Canada
|
Yes, travel adjustment is what you are looking for, consider it synonymous. If it were a nitro bird it would literally change the throttle servo travel, the castle will just interpret the signal.
__________________
Nano CPX || 130X || 230S II 450 3D converted to 450X || 360CFX || 480 Fusion II 550X || Oxy 5 MEG || ALeeS Rush 700 Evolution || Goblin 770 Sport 'My flight style, determines my crash style" |
Thread Tools | |
Display Modes | |
|
|