700 Logo

[Charlie R]

I know a stock Logo 700 can spin 753mm main blades .Does anyone know if it could spin
Rail R-766 Main Blades ?
I am guessing the would hit the tail .
Thanks

[Qrrambero]

Get the Rails and sale me those Edges 756 ;-)

[mat081278]

If you plan to do hard 3D, I will not advice you to use more than stock length.
Even with stock length 710mm (or so) I have succeed to touch the boom.
Not a full boom strike but a little touch on the boom.

I think that with longer blades it should have been a disaster.

[corona007]

Yup, I also dinged my boom with 710's

[Laughingstill]

Originally Posted by mat081278

If you plan to do hard 3D, I will not advice you to use more than stock length.
Even with stock length 710mm (or so) I have succeed to touch the boom.
Not a full boom strike but a little touch on the boom.

I think that with longer blades it should have been a disaster.

Originally Posted by corona007

Yup, I also dinged my boom with 710's

You guys over 8 degrees on the cyclic setup?

[corona007]

I'm at 8.

[Charlie R]

I have been running 753 for 2 years now with no trouble .
8 degrees on the cyclic .

[corona007]

Originally Posted by Charlie R

I have been running 753 for 2 years now with no trouble .
8 degrees on the cyclic .

Wait wuttt??

I misunderstood your 1 post. I got side tracked when someone mentioned the boom. So I was commenting on the boom. lol

If your not kissing the boom with 753 and 8 cycling maybe you can get away with 766.

I'm almost positive you can find the dimension of the root to tip of 766 and measure your blade bolt to tail blade.