Register Now

Chris Nifty · 05-21-2015, 05:02 AM

Hey guys, in the event of drawing too much current, is the shut down a hard one or a slow down like when you set slow down for lvc? This is for the 120lvk. I've just installed an Xnova 4025-1120 in a 550 and believe the amps could get up there if pushed.

waxman · 05-21-2015, 05:09 PM

Dont stress, that motor will not shutdown that esc unless your some sort of freak. Not sure about the cut off? I've never had a yge cut but I have with a kosmik whick was a hard cut. I think the only soft cut most manufactures offer is with lvc. And kosmik has a capacity sift cut as well.

Chris Nifty · 05-22-2015, 01:18 AM

Awesome, thanks Waxy!

05-21-2015, 05:02 AM	#1 (permalink)
Chris Nifty Registered Users Join Date: Dec 2011	Overload hard cut or slow down? Hey guys, in the event of drawing too much current, is the shut down a hard one or a slow down like when you set slow down for lvc? This is for the 120lvk. I've just installed an Xnova 4025-1120 in a 550 and believe the amps could get up there if pushed. __________________ Mini Protos, Voodoo 400, Protos 380, Protos Leggero 700 & 700X, Diabolo 700

05-22-2015, 01:18 AM	#3 (permalink)
Chris Nifty Registered Users Thread Starter Join Date: Dec 2011	Awesome, thanks Waxy! __________________ Mini Protos, Voodoo 400, Protos 380, Protos Leggero 700 & 700X, Diabolo 700

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-21-2015, 05:09 PM	#2 (permalink)
waxman Registered Users Join Date: Aug 2009	Dont stress, that motor will not shutdown that esc unless your some sort of freak. Not sure about the cut off? I've never had a yge cut but I have with a kosmik whick was a hard cut. I think the only soft cut most manufactures offer is with lvc. And kosmik has a capacity sift cut as well.

Register Now

Log-in