End points adjustment of max. and min. collective

[lcc014]

I just finished max. and min. collective pitch adjustment under Swash Servos tab and Interface set to Advanced. Swashplate were level at min, mid-stick and max. However, when I disconnected gyro from PC and power up the heli with main battery, max. and min swashplate positions were not level at all. I reconnected gyro to PC software and checked again, all 3 (min. mid and max.) swashplate positions were level again.

Is this normal: Swashplate level at max. and min when connected gyro to setup but not necessary level when disconnected from setup on the bench ?

Thanks.

[RontaryUS]

Yes, this is normal behavior and you will have some elevator compensation (forward at positive pitch and backward at negative pitch) in flight mode (not connected).

[Xrayted]

Originally Posted by lcc014

I just finished max. and min. collective pitch adjustment under Swash Servos tab and Interface set to Advanced. Swashplate were level at min, mid-stick and max. However, when I disconnected gyro from PC and power up the heli with main battery, max. and min swashplate positions were not level at all. I reconnected gyro to PC software and checked again, all 3 (min. mid and max.) swashplate positions were level again.

Is this normal: Swashplate level at max. and min when connected gyro to setup but not necessary level when disconnected from setup on the bench ?

Thanks.

https://www.helifreak.com/showpost.p...09&postcount=2

[lcc014]

Thank you for the clarification.