servo setup

[dizzymarkus]

Howdy fellas,
New Scrimok owner and had a few questions I was hopeing someone could help me out with. The is only my second shot at flybarless setup and Im at the servo point. I cannot get the arms to line up exactly at 90 like they should. Heres where I get grey hehe -- can I use subtrim to get the arms @ 90 I didnt think I could with FBL -- if not how do I adjust them so there 90?


thanks greatly

Markus

[Mercuriell]

You get the arms as close as you can using the splines on the servo arm then check the stainless steel discs VERY carefully and you will see they are offset 5° - if you get them aligned correct you will be very nearly at 90. DOn't use subtrim with FBL - you can trim the swash level from the FBL program during setup.

[dizzymarkus]

Thanks greatly for the response--- funny in the mean time I came across your setup videos :0)

thanks again,
Markus